Battery Holder - 4xAA to Barrel Jack Connector
This is a simple 4 cell AA battery holder.
The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector.
The connector mates with the barrel jack on the Arduino (among a number of other products)
allowing you to easily make your project battery powered.
Note: the average voltage regulator has about 1V of dropout (but can vary greatly).
This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V.
This depends a lot of what board and processor you are using with the battery pack.
Please consult yer datasheet.
