10 sets M3 * 10 hexagonal standoffs mounting kit
₪25
10 sets M3 * 10 hexagonal standoffs mounting kit Suitable for all kinds of circuit boards, sensors, mechanical support of the installation. ..
10 sets M3 * 30 hexagonal standoffs mounting kit
₪25
10 sets M3 * 30 hexagonal standoffs mounting kit Suitable for all kinds of circuit boards, sensors, mechanical support of the installation. ..
10 sets M3 * 50 hexagonal standoffs mounting kit
₪35
10 sets M3 * 50 hexagonal standoffs mounting kit Suitable for all kinds of circuit boards, sensors, mechanical support of the installation. ..
Center Hole Adapters - 4 pack
₪16
These center hole adaptors come in packs of four, are .08” thick, and have an outer diameter .54”. Their ½” diameter lip allows them to fit snuggly in..
Shaft Spacer - 1/2"
₪14
These plastic shaft spacers have an inner diameter of 1/2” and a thickness of 1/16”. These spacers are ideal for spacing out an area between a bearing..
Shaft Spacer - 5/8"
₪14
These plastic shaft spacers have an inner diameter of 5/8” and a thickness of 1/16”. These spacers are ideal for spacing out an area between a bearing..
Silicone Bumpers - Large (10x16.5mm, 4 pack)
₪9
Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a projec..
Standoff - Metal Hex (4-40; 3/8"; 10 pack)
₪33
Metal Hex Male/Female standoffs. #4-40 thread with 3/8" shank and 3/16" thread length. Can be stacked to create any length.Pack of 10..
Standoff - Nylon (4-40; 3/8"; 10 pack)
₪26
These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off th..
Standoffs Plastic (4-40; 3/8"; 10 pack)
₪26
These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off th..
Standoffs Plastic - (4-40; 3/4"; 10 pack)
₪31
These nylon standoffs are 3/4" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off th..
