Monster Moto Shield
This is essentially a ramped up version of our Ardumoto motor driver shield.
For this monster shield we've replaced the L298 H-bridge with a pair of
VNH2SP30 full-bridge motor drivers.
We've also beefed up the support circuitry so this board is
capable of driving a pair of high-current motors!
The VIN and motor out are pitched for our 5mm screw terminals (not included),
making it easy to connect larger gauge wires.
Note: When using this board in extreme high-demand applications
it may be necessary to improve thermal performance
with a heat-sink or fan and to solder the wires directly to the board instead
of using a screw terminal (in addition to the myriad other complications
present in a high-current system) However,
when using the board at currents up to 6A the chips will barely become noticeably warm.
מאפיינים:
- Voltage max: 16V
- Maximum current rating: 30 A
- Practical Continuous Current: 14 A
- Current sensing available to Arduino analog pin
- MOSFET on-resistance: 19 mΩ (per leg)
- Maximum PWM frequency: 20 kHz
- Thermal Shutdown
- Undervoltage and Overvoltage shutdown
תיעוד:
- Schematic
- Eagle Files
- Datasheet (VNH2SP30)
- Example Code